LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Manual Transmission) >> RS6F94R >> Final Drive >> Disassembly and Assembly >> Disassembly

Disassembly and Assembly: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Remove differential side bearing inner race (clutch housing side) (1) using Tool (A) and a suitable tool.

    Tool number A: ST33061000 (J-8107-2) 

  2. Remove speedometer drive gear.
    Fig 1: Identifying Speedometer Drive Gear
    G04926480Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Remove final gear bolts (1), and then separate the final gear (2) from differential case.
    Fig 2: Identifying Final Gear Bolts From Differential Case
    G04926481Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Remove differential side bearing inner race (transaxle case side) (1) using a suitable tool (A).
    Fig 3: Identifying Differential Side Bearing Inner Race
    G04926482Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Remove lock ring (1) from differential case.
  6. Remove pinion mate shaft, pinion mate gears, side gears and thrust washer from differential case.
    Fig 4: Identifying Lock Ring From Differential Case
    G04926483Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals