Fork Rod and Shift Fork
WARNING: This page is about a different variant/trim than selected.
- Check contact surfaces and sliding area for wear, damage, bending, etc. If necessary, replace parts.
- Check if the width of shift fork hook (sliding area with coupling sleeve) is within allowable specification below.COUPLING SLEEVE SPECIFICATIONS
Item One-side wear specification Sliding width of new part 1st-2nd 0.2 mm (0.008 in) 7.80 - 7.93 mm (0.3071 - 0.3122 in) 3rd-4th 0.2 mm (0.008 in) 7.80 - 7.93 mm (0.3071 - 0.3122 in) 5th-6th 0.2 mm (0.008 in) 6.10 - 6.23 mm (0.2402 - 0.2453 in) Reverse 0.2 mm (0.008 in) 12.80 - 12.93 mm (0.5039 - 0.5091 in)