Changing M/T Oil: Filling
WARNING: This page is about a different variant/trim than selected.
- Remove plug (with ABS models) (1) or speedometer pinion gear (without ABS models) (1). Fill with new oil to transaxle.
A : Suitable gauge
Oil grade and viscosity : Refer to "MR20DE ".
Oil capacity (reference) : Refer to "GENERAL SPECIFICATIONS ".
- After refilling oil, check oil level.
- Set a O-ring on plug (with ABS models) (1) or speedometer pinion gear (without ABS models) (1) and then install it to transaxle. Tighten mounting bolt to the specified torque. Refer to
"CASE AND HOUSING COMPONENTS ".CAUTION: Never reuse O-ring.