LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Manual Transmission) >> RS6F52H >> Input Shaft And Gears >> Disassembly and Assembly >> Disassembly

Disassembly and Assembly: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Before disassembling, measure end play for 3rd, 4th, 5th, and 6th input gears.

    End play standard value 

    : Refer to  "GEAR END PLAY ".

  2. Remove oil channel.
    Fig 1: Checking End Play Of 3rd, 4th, 5th And 6th Input Gears
    G04888956Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Press out input shaft rear bearing using the drift and a puller.
  4. Remove snap ring.
    Fig 2: Identifying Input Shaft Rear Bearing
    G04888957Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Press out 6th input gear, 6th needle bearing, 6th input gear bushing, 5th-6th synchronizer hub assembly, and 5th input gear using the drift (A) [SST: ST33052000 ( - )] and a puller (B).
  6. Remove 5th needle bearing.
    Fig 3: Identifying Drift And Puller On 6th Input Gear Bushing, 5th-6th Synchronizer Hub Assembly
    G04888958Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Press out 5th input gear bushing, thrust washer, 4th input gear, 4th needle bearing, 4th input gear bushing, 3rd-4th synchronizer hub assembly, and 3rd input gear using the drift and a puller.
  8. Remove 3rd needle bearing.
    Fig 4: Removing 3rd Needle Bearing Using Puller
    G04888959Courtesy of NISSAN MOTOR CO., U.S.A.
  9. Press out input shaft front bearing using a puller.
    Fig 5: Identifying Puller On Input Shaft Front Bearing
    G04888960Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals