LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Manual Transmission) >> RS6F52A >> M/T Oil >> Checking M/T Oil >> Oil Leakage And Oil Level

Oil Leakage And Oil Level

WARNING: This page is about a different variant/trim than selected.
  1. Make sure that oil is not leaking from transaxle or around it.
  2. Remove plug (with ABS models) (1) or speedometer pinion gear (without ABS models) (1).
  3. Measure oil level using a suitable gauge (A) as shown in the figure, and then check if it is within the specifications.

    Oil level "L" : Refer to  "GENERAL SPECIFICATIONS ".

    CAUTION: Never start engine while checking oil level.
  4. Set a O-ring on plug (with ABS models) (1) or speedometer pinion gear (without ABS models) (1) and then install it to transaxle. Tighten mounting bolt to the specified torque. Refer to "CASE AND HOUSING COMPONENTS ".
    CAUTION: Never reuse O-ring.
    Fig 1: Identifying Plug Or Speedometer Pinion Gear
    G04928832Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals