Changing M/T Oil: Filling

WARNING: This page is about a different variant/trim than selected.

Remove plug (with ABS models) (1) or speedometer pinion gear (without ABS models) (1). Fill with new oil to transaxle.
A : Suitable gauge

Oil grade and viscosity : Refer to "MR20DE ".

Oil capacity (reference) : Refer to "GENERAL SPECIFICATIONS ".

Fig 1: Identifying Plug Or Speedometer Pinion Gear
Courtesy of NISSAN MOTOR CO., U.S.A.
After refilling oil, check oil level.
Set a O-ring on plug (with ABS models) (1) or speedometer pinion gear (without ABS models) (1) and then install it to transaxle. Tighten mounting bolt to the specified torque. Refer to "CASE AND HOUSING COMPONENTS ".
CAUTION: Never reuse O-ring.