LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Manual Transmission) >> RS6F52A >> Control Linkage >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove battery. Refer to "REMOVAL AND INSTALLATION QR25DE ".
  2. Remove air cleaner and air duct. Refer to "REMOVAL AND INSTALLATION ".
  3. Remove shift cable from shifter lever.
    Fig 1: Identifying Shift Cable From Shifter Lever
    G04926378Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Remove select cable from selector lever A.
    Fig 2: Identifying Select Cable From Selector Lever A
    G04926379Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Shift control lever to neutral position.
  6. Remove control lever knob.
  7. Remove center console assembly. Refer to "CENTER CONSOLE ASSEMBLY ".
  8. Remove control device assembly nuts.
  9. Remove exhaust front tube, center muffler and heat shield. Refer to "REMOVAL AND INSTALLATION ".
  10. Remove cable support bracket.
  11. Remove select cable and shift cable from cable bracket.
  12. Remove control device assembly from the vehicle.
scientia non olet · About LEMON Manuals