Special Service Tools

WARNING: This page is about a different variant/trim than selected.

The actual shapes of the Kent-Moore tools may differ from those of the special service tools illustrated here.

SPECIAL SERVICE TOOLS REFERENCE

Tool number (Kent-Moore No.) Tool name		Description
KV10111100 (J-37228) Seal cutter	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing steel oil pan and rear timing chain case
ST0501S000 Engine stand assembly 1. ST05011000 ( - ) Engine stand 2. ST05012000 ( - ) Base	Courtesy of NISSAN MOTOR CO., U.S.A.	Disassembling and assembling
KV10106500 ( - ) Engine stand shaft	Courtesy of NISSAN MOTOR CO., U.S.A.
KV10115300 ( - ) Engine sub-attachment	Courtesy of NISSAN MOTOR CO., U.S.A.
KV10116200 (J-26336-B) Valve spring compressor 1. KV10115900 (J-26336-20) Attachment	Courtesy of NISSAN MOTOR CO., U.S.A.	Disassembling valve mechanism
KV10112100 (BT-8653-A) Angle wrench	Courtesy of NISSAN MOTOR CO., U.S.A.	Tightening bolts for bearing cap, cylinder head, etc.
KV10107902 (J-38959) Valve oil seal puller	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing valve oil seal
KV10115600 (J-38958) Valve oil seal drift	Courtesy of NISSAN MOTOR CO., U.S.A.	Installing valve oil seal Use side A. a: 20 (0.79) dia. b: 13 (0.51) dia. c: 10.3 (0.406) dia. d: 8 (0.31) dia. e: 10.7 (0.421) dia. f: 5 (0.20) dia. Unit: mm (in)
EM03470000 (J-8037) Piston ring compressor	Courtesy of NISSAN MOTOR CO., U.S.A.	Installing piston assembly into cylinder bore
ST16610001 (J-23907) Pilot bushing puller	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing crankshaft pilot bushing
WS39930000 ( - ) Tube presser	Courtesy of NISSAN MOTOR CO., U.S.A.	Pressing the tube of liquid gasket
16441 6N210 (J-45488) Quick connector release	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing fuel tube quick connectors in engine room (Available in SEC. 164 of PARTS CATALOG: Part No. 16441 6N210)
KV10114400 (J-38365) Heated oxygen sensor wrench	Courtesy of NISSAN MOTOR CO., U.S.A.	Loosening or tightening rear heated oxygen sensor a: 22 mm (0.87 in)
KV10117100 (J-36471-A) Heated oxygen sensor wrench	Courtesy of NISSAN MOTOR CO., U.S.A.	Loosening or tightening heated oxygen sensor For 22 mm (0.87 in) hexagon nut
- (J-44626) Air fuel ratio (A/F) sensor wrench	Courtesy of NISSAN MOTOR CO., U.S.A.	Loosening or tightening air fuel ratio (A/F) sensor 1
- (J-46535) Drive belt tension releaser	Courtesy of NISSAN MOTOR CO., U.S.A.	Releasing drive belt tension