Commercial Service Tools

WARNING: This page is about a different variant/trim than selected.

COMMERCIAL SERVICE TOOLS REFERENCE

Tool number (Kent-Moore No.) Tool name		Description
Pulley holder	Courtesy of NISSAN MOTOR CO., U.S.A.	Crankshaft pulley removing and installing a: 68 mm (2.68 in) dia. b: 8 mm (0.31 in) dia.
Crank puller	Courtesy of NISSAN MOTOR CO., U.S.A.	Crankshaft pulley removing
Spark plug wrench	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing and installing spark plug
Valve seat cutter set	Courtesy of NISSAN MOTOR CO., U.S.A.	Finishing valve seat dimensions
Piston ring expander	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing and installing piston ring
Valve guide drift	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing and installing valve guide Intake & Exhaust: a: 9.5 mm (0.374 in) dia. b: 5.5 mm (0.217 in) dia.
Valve guide reamer	Courtesy of NISSAN MOTOR CO., U.S.A.	Reaming valve guide inner hole Reaming hole for oversize valve guide Intake & Exhaust: d1 : 6.0 mm (0.236 in) dia. d2 : 10.2 mm (0.402 in) dia.
(J-43897-18) (J-43897-12) Oxygen sensor thread cleaner	Courtesy of NISSAN MOTOR CO., U.S.A.	Reconditioning the exhaust system threads before installing a new heated oxygen sensor (Use with anti-seize lubricant shown below.) a: J-43897-18 [18 mm (0.71 in) dia.] for zirconia heated oxygen sensor b: J-43897-12 [12 mm (0.47 in) dia.] for Titania heated oxygen sensor
Anti-seize lubricant (Permatex 133AR or equivalent meeting MIL specification MIL-A-907)	Courtesy of NISSAN MOTOR CO., U.S.A.	Lubricating oxygen sensor thread cleaning tool when reconditioning exhaust system threads
Power tool	Courtesy of NISSAN MOTOR CO., U.S.A.	Loosening bolts and nuts
TP55 Torx® plus Bit	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing and installing M/T flywheel bolts
E20 Torx® Socket (J-45816)	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing and installing CVT drive plate bolts