Removal and Installation: Installation: Notes

WARNING: This page is about a different variant/trim than selected.

Install the intake manifold bolts and nuts in the reverse order of removal, following the tightening sequences below.

Tightening Intake Manifold Bolts and Nuts

Tighten in numerical order as shown.
CAUTION: After tightening No.5, retighten the No.1 bolt to specification.

Fig 1: Intake Manifold Bolt Tightening Sequence
Courtesy of NISSAN MOTOR CO., U.S.A.

Installation of Electric Throttle Control Actuator:

Tighten the mounting bolts of electric throttle control actuator equally and diagonally in several steps.
After installation perform procedure in "INSPECTION AFTER INSTALLATION ".