LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical (Qr25DE)) >> Cylinder Block >> How to Select Piston and Bearing >> How To Select A Connecting Rod Bearing >> When New Connecting Rod and Crankshaft are Used

When New Connecting Rod and Crankshaft are Used

WARNING: This page is about a different variant/trim than selected.
  1. Apply big end inside diameter grade stamped on connecting rod side face to the row in the "Connecting Rod Bearing Selection Table".
    Fig 1: Applying Big End Inside Diameter Grade Stamped On Connecting Rod Side Face
    G04885851Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Apply pin diameter grade stamped on crankshaft front side to the column in the "Connecting Rod Bearing Selection Table".
  3. Read the symbol at the cross point of selected row and column in the "Connecting Rod Bearing Selection Table".
  4. Apply the symbol obtained to connecting rod bearing grade table to select.
    • A: Journal diameter
    • B: Pin diameter
      Fig 2: Identifying Connecting Rod Bearing Grade
      G04924918Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals