Inner Diameter of Camshaft Bracket

WARNING: This page is about a different variant/trim than selected.

Tighten the camshaft bracket bolts to the specified torque following the tightening pattern as shown. Refer to Step 4 of "INSTALLATION ", of "CAMSHAFT" for the specified torque sequence.

Fig 1: Camshaft Bracket Bolt Tightening Sequence
Courtesy of NISSAN MOTOR CO., U.S.A.
Using inside micrometer, measure inner diameter of camshaft bracket.
Standard No.1 : 28.000 - 28.021 mm (1.1024 - 1.1032 in)

Standard No.2, 3, 4, 5 : 23.500 - 23.521 mm (0.9252 - 0.9260 in)

Fig 2: Measuring Inner Diameter Of Camshaft Bracket
Courtesy of NISSAN MOTOR CO., U.S.A.