LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical (Qr25DE)) >> Camshaft >> Removal and Installation >> Inspection After Removal >> Camshaft Journal Clearance >> Camshaft Sprocket Runout

Camshaft Sprocket Runout

WARNING: This page is about a different variant/trim than selected.
  1. Install the camshaft in the cylinder head.
  2. Install the camshaft sprocket on the camshaft.
  3. Measure camshaft sprocket runout while turning the camshaft by hand.

    Runout : Less than 0.15 mm (0.0059 in) 

  4. If it exceeds the specification, replace camshaft sprocket.
    Fig 1: Checking Camshaft Sprocket Runout
    G04899735Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals