LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Control System - DTCS P1148 To P2A03 (Qr25DE)) >> DTC P2A00, P2A03 A/F Sensor 1 >> DTC Confirmation Procedure >> With Consult-III

With Consult-III

WARNING: This page is about a different variant/trim than selected.
  1. Start engine and warm it up to normal operating temperature.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Turn ignition switch ON and select "SELF-LEARNING CONT" in "WORK SUPPORT" mode with CONSULT-III.
  4. Clear the self-learning coefficient by touching "CLEAR".
  5. Turn ignition switch OFF and wait at least 10 seconds.
  6. Start engine and keep the engine speed between 3, 500 and 4, 000 RPM for 1 minute under no load.
  7. Let engine idle for 1 minute.
  8. Keep engine speed between 2, 500 and 3, 000 RPM for 20 minutes.
  9. Check 1st trip DTC.
  10. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About LEMON Manuals