LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Control System - DTCS P1148 To P2A03 (Qr25DE)) >> DTC P2119 Electric Throttle Control Actuator >> DTC Confirmation Procedure >> Procedure For Malfunction C

Procedure For Malfunction C

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch ON and wait at least 1 second.
  2. Set shift lever to D position (CVT) or 1st position (M/T) and wait at least 3 seconds.
  3. Set shift lever to P or N position (CVT) or Neutral (M/T) position.
  4. Start engine and let it idle for 3 seconds.
  5. Check DTC.
  6. If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About LEMON Manuals