LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Control System - DTCS P1148 To P2A03 (Qr25DE)) >> DTC P1715 Input Speed Sensor (Primary Speed Sensor) >> DTC Confirmation Procedure >> With Consult-III

With Consult-III

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-III.
  3. Start engine.
  4. Drive vehicle at a speed of more than 50 km/h (31 MPH) for at least 5 seconds.
  5. Check 1st trip DTC.
  6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About LEMON Manuals