LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SL >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Cooling System (Qr25DE)) >> Water Pump >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Drain coolant. Refer to "CHANGING ENGINE COOLANT ".
    CAUTION: Perform when the engine is cold.
  2. Remove engine undercover using power tools.
  3. Remove drive belt. Refer to "REMOVAL ".
  4. Remove engine cover using power tools.
  5. Remove engine coolant reservoir.
  6. Remove IPDM E/R (set aside). Refer to "REMOVAL ".
  7. Remove RH wheel and tire assembly.
  8. Remove fender protector. Refer to "REMOVAL ".
  9. Remove engine ground strap.
  10. Remove the water pump.
    NOTE: If necessary, the generator and exhaust manifold catalytic convertor assembly must be removed to remove the water pipe.
    CAUTION:
    • Handle the water pump vane so that it does not contact any other parts.
    • Water pump cannot be disassembled and should be replaced as an assembly.
scientia non olet · About LEMON Manuals