Inspection After Removal: Notes

WARNING: This page is about a different variant/trim than selected.

Place a thread so that it is caught in the valve of the water control valve. Immerse fully in a container filled with water. Heat while stirring.
The valve opening temperature is the temperature at which the valve opens and the falls from the thread.
Continue heating. Check the full-open lift amount.
NOTE: The full-open lift amount standard temperature for the water control valve is the reference value.
After checking the full-open lift amount, lower the water temperature and check the valve closing temperature.

Fig 1: Identifying Thread Inspection
Courtesy of NISSAN MOTOR CO., U.S.A.