Removal Of Liquid Gasket Sealing

WARNING: This page is about a different variant/trim than selected.

After removing nuts and bolts, separate the mating surface, using Tool and remove old liquid gasket sealing.
Tool number : KV10111100 (J-37228)

CAUTION: Be careful not to damage the mating surfaces.
Tap Tool to insert it, and then slide it by tapping on the side as shown in the figure.
In areas where Tool is difficult to use, use plastic hammer to lightly tap the parts, to remove it.
CAUTION: If for some unavoidable reason suitable tool such as screwdriver is used, be careful not to damage the mating surfaces.

Fig 1: Identifying Special Tool Location
Courtesy of NISSAN MOTOR CO., U.S.A.