Checking For Coolant Leaks

WARNING: This page is about a different variant/trim than selected.

To check for leakage, apply pressure to the cooling system using Tool.

Tool number : EG17650301 (J-33984-A)

Testing pressure : 157 kPa (1.6 kg/cm ² , 23 psi)

Fig 1: Checking Leakage

Courtesy of NISSAN MOTOR CO., U.S.A.

WARNING: Never remove the radiator cap when the engine is hot. Serious burns could occur from high pressure coolant escaping from the radiator.

CAUTION: Higher pressure than specified may cause radiator damage.