Only Front Wiper LO Does Not Operate

With CONSULT-III 

1. Select "IPDM E/R" on CONSULT-III, and select "ACTIVE TEST".
2. Select "FRONT WIPER" on "SELECT TEST ITEM" screen.
3. Touch "LO" screen.

Without CONSULT-III 

Start auto active test. Refer to "AUTO ACTIVE TEST ".

Does front wiper operate normally? 

YES: Refer to "COMBINATION SWITCH INSPECTION ".

NO: GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect IPDM E/R and front wiper motor.
3. Check continuity between IPDM E/R connector (A) and front wiper motor connector (B).
   CONNECTOR TERMINAL CONTINUITY SPECIFICATION
   
   

   Connector	Terminal	Connector	Terminal	Continuity
   A		B
   E45	33	E1	1	Yes

4. Check continuity between IPDM E/R harness connector (A) and ground.

Fig 1: Checking Continuity Between IPDM E/R Connector And Front Wiper Motor Connector

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: GO TO 3.

NG: Repair or replace harness.

With CONSULT-III 

1. Connect IPDM E/R.
2. Turn ignition ON.
3. Select "IPDM E/R" on CONSULT-III, and select "ACTIVE TEST".
4. Select "FRONT WIPER" on "SELECT TEST ITEM" screen.
5. Touch "LO" screen.
6. Check voltage between IPDM E/R connector and ground while front wiper LO is operating.

Without CONSULT-III 

1. Connect IPDM E/R.
2. Turn ignition ON.
3. Start auto active test. Refer to "AUTO ACTIVE TEST ".
4. Check voltage between IPDM E/R connector and ground while front wiper LO is operating.

Fig 2: Checking Voltage Between IPDM E/R Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Replace front wiper motor. Refer to "REMOVAL AND INSTALLATION OF FRONT WIPER DRIVE ASSEMBLY ".

NG: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION OF IPDM E/R ".