LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2008 >> Sentra SE-R >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel >> Instrument Panel Assembly >> Removal and Installation >> Cluster Lid C >> Removal

Cluster Lid C: Removal

  1. Remove the shifter knob. Refer to "SELECTOR LEVER KNOB REMOVAL AND INSTALLATION " (CVT), "COMPONENTS OF CONTROL DEVICE AND CABLE " (MT).
  2. Remove the CVT or MT finisher.
  3. Remove the controller and controller finisher, disconnect the controller finisher connectors.
  4. Remove the cluster lid C upper mask (base).
  5. Remove the double meter (1) (SE-R).
    Fig 1: Identifying Double Meter
    G04928060Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Remove cluster lid C (1).
  1. Remove cluster lid C screws (A).
  2. Pull out cluster lid C (1) to disconnect harness connector and remove cluster lid C (1).
    Fig 2: Identifying Cluster Lid C And Cluster Lid C Screws
    G04928061Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals