Malfunction Code No. 21, 22, 23, 24, DTC C1708, C1709, C1710 Or C1711

Drive for several minutes. Check all tire pressures with CONSULT-III.

Are all tire pressures displayed as 0 kPa? 

YES: GO TO 2.

NO: GO TO  3.

Check remote keyless entry receiver connector for damage or loose connections.

Is the remote keyless entry receiver connector damaged or loose? 

YES: Repair or replace remote keyless entry receiver connector.

NO: Replace BCM, then GO TO 3. Refer to "REMOVAL AND INSTALLATION OF BCM ".

Carry out ID registration of all transmitters. Refer to "ID REGISTRATION PROCEDURE ".

Is there a tire that cannot register ID? 

YES: Replace transmitter of the tire, then GO TO  5. Refer to "TRANSMITTER (PRESSURE SENSOR) ".

NO: GO TO 4.

1. Drive at a speed of 40 km/h (25 MPH) or more for several minutes without stopping.
2. Check all tire pressures with CONSULT-III within 15 minutes after vehicle speed becomes 17 km/h (11 MPH).

Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp? 

YES: Inspection End.

NO: GO TO 5.

1. Carry out ID registration of all transmitters. Refer to "ID REGISTRATION PROCEDURE ".
2. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.
3. Check all tire pressures with CONSULT-III within 5 minutes.

Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp? 

YES: Inspection End.

NO: GO TO the inspection applicable to DTC.