LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2007 >> Sentra SE-R >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel Assembly >> Removal and Installation >> Glove Box Assembly >> Removal

Glove Box Assembly: Removal

  1. Remove the shifter knob. Refer to "SELECTOR LEVER KNOB REMOVAL AND INSTALLATION " (CVT), "COMPONENTS OF CONTROL DEVICE AND CABLE " (MT).
  2. Remove the CVT or MT finisher.
  3. Remove the controller and controller finisher, disconnect the controller finisher connectors.
  4. Remove the cluster lid C upper mask (base).
  5. Remove the double meter (1) (SE-R).
    Fig 1: Identifying Double Meter
    G04928060
  6. Remove cluster lid C (1).
    1. Remove cluster lid C screws (A).
    2. Pull out cluster lid C (1) to disconnect harness connector and remove cluster lid C (1).
      Fig 2: Identifying Cluster Lid C And Cluster Lid C Screws
      G04928061
  7. Remove the instrument panel trim (RH).
  8. Remove glove box lower finisher screws, remove glove box lower finisher.
    Fig 3: Identifying Glove Box Lower Finisher Screws
    G04928062
  9. Remove the glove box assembly
    1. Remove the two lower glove box assembly screws (A).
    2. Open the glove box and remove the four upper glove box assembly screws (B).
      Fig 4: Identifying Lower Glove Box Assembly Screws And Upper Glove Box Assembly Screws
      G04928063
scientia non olet · About LEMON Manuals