Diagnostic Procedure 6

"SECURITY INDICATOR LAMP DOES NOT LIGHT UP"

1. CHECK FUSE 

   Check 10A fuse [No. 12, located in the fuse block (J/B)].

   Is 10A fuse OK? 

   Yes: GO TO 2.

   No: Replace fuse.

2. CHECK SECURITY INDICATOR LAMP 
   1. Install 10A fuse.
   2. Perform initialization with CONSULT-II.

      For initialization, refer to "CONSULT-II OPERATION MANUAL IVIS/NVIS".

   3. Turn ignition switch OFF.
   4. Start engine and turn ignition switch OFF.
   5. Check the security indicator lamp lighting.

   Security indicator lamp should light up. 

   OK or NG 

   OK: INSPECTION END 

   NG: GO TO 3.

3. CHECK SECURITY INDICATOR LAMP POWER SUPPLY CIRCUIT 
   1. Disconnect security indicator lamp connector.
   2. Check voltage between security indicator lamp connector terminal 1 and ground.
   Fig 1: Checking Voltage Between Security Indicator Lamp Connector Terminal 1 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

   OK or NG 

   OK: GO TO 4.

   NG: Check harness for open or short between fuse and security indicator lamp.

4. CHECK SECURITY INDICATOR LAMP 

   Check security indicator lamp.

   Is security indicator lamp OK? 

   Yes: GO TO 5.

   No: Replace security indicator lamp.

5. CHECK NVIS (NATS) IMMU FUNCTION 
   1. Connect NVIS (NATS) IMMU connector.
   2. Disconnect security indicator lamp connector.
   3. Check continuity between NVIS (NATS) IMMU terminal 5 and ground.
   Fig 2: Checking Continuity Between NVIS (NATS) IMMU Terminal 5 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

   OK or NG 

   OK: Check harness for open or short between security indicator lamp and NVIS (NATS) IMMU.

   NG:

   • NVIS (NATS) IMMU is malfunctioning.
   • Replace NVIS (NATS) IMMU. Ref. part No. A 
   • Perform initialization with CONSULT-II.
   • For initialization, refer to "CONSULT-II OPERATION MANUAL IVIS/NVIS".