Removal Of Liquid Gasket Sealing

After removing the mounting bolts and nuts, separate the mating surface using Tool and remove the liquid gasket sealing.
Tool number KV10111100 (J-37228)

CAUTION: Be careful not to damage the mating surfaces.

In areas where the cutter is difficult to use, use a plastic hammer to lightly tap (1) the cutter where the Silicone RTV Sealant is applied. Use a plastic hammer to slide the cutter (2) by tapping on the side.

Fig 1: Removing Liquid Gasket Sealing

Courtesy of NISSAN MOTOR CO., U.S.A.

CAUTION: If for some unavoidable reason a tool such as a flat-bladed screwdriver is used, be careful not to damage the mating surfaces.