Removal Of Liquid Gasket

After removing the bolts and nuts, disconnect and remove the sealant using Tool.
Tool number: KV10111100 (J-37228)

CAUTION: Be careful not to damage the mating surfaces.

In areas where the cutter is difficult to use, use a plastic hammer to lightly tap the sealant applied area.

CAUTION: If for some unavoidable reason a tool such as a flat-blade screwdriver is used, be careful not to damage the mating surfaces.

Fig 1: Tapping Mating Surface Of Oil Pan With Plastic Hammer

Courtesy of NISSAN MOTOR CO., U.S.A.