High Beam Operation/Flash-to-pass Operation

When the lighting switch is moved to headlamp "ON" (2ND) position, "HIGH BEAM" (A) or "FLASH TO PASS" (C) position, power is supplied

from lighting switch terminal 6
to RH headlamp terminal HI, and
from lighting switch terminal 9
to daytime light control unit terminal 5, and
to combination meter terminal 2 (with tachometer), 12 (without tachometer) for the high beam indicator
through daytime light control unit terminal 6
to LH headlamp terminal HI.

Ground is supplied in the same manner as low beam operation.

For the combination meter, ground is supplied

With power and ground supplied, the high beam headlamps and high beam indicator illuminate.