Removal and Installation: Removal
- Disconnect the Mass Air Flow (MAF) sensor electrical connector.
- Disconnect the tube clamp at the electric throttle control actuator.
- Remove air cleaner to electric throttle control actuator tube and air cleaner case (upper) with the mass air flow sensor attached.
- Do not shock it.
- Do not disassemble it.
- Do not touch the internal sensor.
- Remove mass air flow sensor from air cleaner case (upper), as necessary.
- Remove the air cleaner element, as necessary and replace it with a new element.
- Remove the air cleaner case (lower).
CAUTION:
Handle the mass air flow sensor with care: