Consult-II Inspection Procedure

1. Turn ignition switch OFF.
   Fig 1: Identifying Pedal

   Courtesy of NISSAN MOTOR CO., U.S.A.
2. Connect "CONSULT-II" to data link connector.
3. Insert NVIS (NATS) program card into CONSULT-II.

   Program card : NATS (AEN02C) 

   Fig 2: Identifying Scan Tool Display

   Courtesy of NISSAN MOTOR CO., U.S.A.
4. Turn ignition switch ON.
5. Touch "START".
6. Select "NATS V.5.0".
   Fig 3: Display Turn Ignition Switch On

   Courtesy of NISSAN MOTOR CO., U.S.A.
7. Perform each diagnostic test mode according to each service procedure.
   Fig 4: Diagnostic Test Mode According To Each Service

   Courtesy of NISSAN MOTOR CO., U.S.A.

For further information, see the "CONSULT-II OPERATION MANUAL IVIS/NVIS".