Remote Keyless Entry System Operation
Power is supplied at all times:
- through 15A fuse [No. 5, located in the fuse block (J/B)]
- to remote keyless entry relay terminals 1, 6 and 3.
Ground is supplied to remote keyless entry relay terminal 2, when the remote keyless entry system is triggered through the smart entrance control unit.
Refer to REMOTE KEYLESS ENTRY SYSTEM .
The remote keyless entry relay is energized.
Power is supplied through terminal 5 of the remote keyless entry relay:
- to front combination lamp LH terminal 3
- to combination meter terminal 35 (with tachometer) or 40 (without tachometer)
- to rear combination lamp LH terminal 2.
Power is supplied through terminal 7 of the remote keyless entry relay:
- to front combination lamp RH terminal 3
- to combination meter terminal 4 (with tachometer) or 41 (without tachometer)
- to rear combination lamp RH terminal 2.
Ground is supplied to terminal 1 of each front combination lamp through body grounds E7 and E37.
Ground is supplied to terminal 4 of each rear combination lamp through body grounds B13 and B19.
Ground is supplied to combination meter terminal 12 (with tachometer) or 39 (without tachometer) through body grounds M28 and M54.
With power and ground supplied, the smart entrance control unit controls the flashing of the hazard warning lamps.