LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Automatic Transaxle) >> DTC Vehicle Speed Sensor MTR >> Diagnostic Trouble Code (DTC) Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch ON and select "DATA MONITOR" mode for "A/T" with CONSULT-II.
    Fig 1: Scan Tool Display "Select System"
    G02886739Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Start engine and accelerate vehicle from 0 to 25 km/h (0 to 16 MPH).
    Fig 2: Scan Tool Display "Select Diag Mode"
    G02886740Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals