With Consult-II

WARNING: This page is about a different variant/trim than selected.

Turn ignition switch ON and select "DATA MONITOR" mode for "A/T" with CONSULT-II.
Touch "MAIN SIGNALS".
Touch "START".
Start engine.
Accelerate vehicle to a speed of more than 10 km/h (6 MPH) with selector lever in D position.

Fig 1: Scan Tool Display "Select System"
Courtesy of NISSAN MOTOR CO., U.S.A.
Release accelerator pedal completely with selector lever in 3 position.

Fig 2: Scan Tool Display "Select Diag Mode"
Courtesy of NISSAN MOTOR CO., U.S.A.
Verify operation of "OVERRUN/C S/V".

Fig 3: Scan Tool Display "Select Diag Mode"
Courtesy of NISSAN MOTOR CO., U.S.A.