Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK DTC
With CONSULT-II
1. Turn ignition switch "ON" and select "SELF DIAGNOSIS" mode for A/T with CONSULT-II.
2. Move selector lever to "R" position.
3. Depress accelerator pedal (Full throttle position).
4. Touch "ERASE".
5. Turn ignition switch "OFF" position for 10 seconds.
  Perform "DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE ".
Is the "CONT UNIT (EEP ROM)" displayed again?
1. Yes: Replace TCM.
2. No: INSPECTION END