LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 3.5L) >> DTC P1805: Brake Switch >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch ON.
  2. Fully depress the brake pedal for at least 5 seconds.
  3. Erase the DTC with CONSULT-II.
  4. Select "DATA MONITOR" mode with CONSULT-II.
  5. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
    Fig 1: CONSULT-II Diagnosis Function Display
    G02885951Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals