LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System - 3.5L) >> DTC P0102, P0103: MAF Sensor >> DTC Confirmation Procedure >> Procedure For DTC P0102 >> With CONSULT-II

With CONSULT-II

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Start engine and wait 5 seconds at most.
  4. If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
    Fig 1: Displaying DATA MONITOR Mode
    G02885288Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals