Removal Of Liquid Gasket Sealing

WARNING: This page is about a different variant/trim than selected.

After removing the mounting bolts and nuts, separate the mating surface using a seal cutter and remove the sealant.
CAUTION: Be careful not to damage the mating surfaces.
In areas where the cutter is difficult to use, use a plastic hammer to lightly tap the areas where the sealant is applied.
CAUTION: If for some unavoidable reason a tool such as a flat-bladed screwdriver is used, be careful not to damage the mating surfaces.

Fig 1: Separate The Mating Surface Using A Seal Cutter And Remove The Sealant
Courtesy of NISSAN MOTOR CO., U.S.A.