LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Lubrication System - 3.5 L) >> Oil Cooler >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Drain the engine oil.
  2. Drain the engine coolant.
  3. Remove the oil filter.
  4. Remove the wheel and tire using power tool.
  5. Remove the splash shield using power tool.
  6. Disconnect the coolant hoses from the oil cooler.
    CAUTION: Do not spill coolant on the drive belt.
  7. Remove the oil cooler from the upper oil pan.
scientia non olet · About LEMON Manuals