LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 999 (Heater & Air Conditioning Control System) >> With Monochrome Display >> Function Diagnosis >> Diagnosis System (HVAC) >> CONSULT-III Function >> Active Test

Active Test

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
ACTIVE TEST CHART

Test item Description
ALL SEG
NOTE:
  • Item can be displayed but cannot be tested.
  • When choosing to turn "ALL SEG" on, error message is displayed but it is not malfunction.
HVAC TEST The operation check of A/C system can be performed by selecting the mode. Refer to the following table for the conditions of each mode.

HVAC TEST

HVAC TEST CHART

  Test item
MODE 1 MODE 2 MODE 3 MODE 4 MODE 5 MODE 6
Mode door position VENT1 B/L1 B/L2 FOOT D/F DEF
Intake door position REC REC 20%FRE FRE FRE FRE
Air mix door position (driver & passenger side) FULL COLD FULL COLD FULL HOT FULL HOT FULL HOT FULL HOT
Blower motor duty ratio 37% 91% 65% 65% 65% 91%
A/C compressor (Magnet clutch) ON ON ON OFF ON ON
NOTE: Perform the inspection of each output device after starting the engine, because the A/C compressor has been operating.