LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 999 (Heater & Air Conditioning Control System) >> With Monochrome Display >> Ecu Diagnosis >> A/C Auto Amp >> Reference Value >> Terminals And Reference Values For A/C Auto Amp

Terminals And Reference Values For A/C Auto Amp

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
TERMINALS AND REFERENCE VALUES FOR A/C AUTO AMP

Terminal No. Wire color Item Ignition switch Condition Value (Approx.)
1 L CAN-H ON - 0 - 5V
2 P CAN-L ON - 0 - 5V
6 L TX (AMP > SW DISP) ON - 0 - 5V
7 P RX (SW > AMP) ON - 0 - 5V
10 L/R LAN signal ON -
G04877986Courtesy of NISSAN MOTOR CO., U.S.A.
11 L/W Power supply for each door motor ON - Battery voltage
15 O Sunload sensor ON - -
16 R/G Intake sensor ON - -
17 V/Y Power supply from ACC ACC - Battery voltage
19 B Ground ON - 0V
20 G Power supply from IGN ON - Battery voltage
26 GR Rear defrost feedback ON Defroster switch ON Battery voltage
Defroster switch OFF 0V
27 G/W Rear defrost ON signal ON Defroster switch ON 0V
Defroster switch OFF Battery voltage
32 L/Y Blower motor control signal ON Fan speed: 1st speed (manual)
G05046089Courtesy of NISSAN MOTOR CO., U.S.A.
34 P Power supply for ambient meter ON - 5V
35 O/B Ambient sensor ON - 0 - 5V
36 LG In-vehicle sensor ON - 0 - 5V
37 B/Y Sensor ground - - 0V
39 B Ground - - 0V
40 Y/R Power supply from BATT - - Battery voltage