Inlet Port Memory Function (REC): Description
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- If the ignition switch is turned to the OFF position while the REC (recycle) switch is set to ON (recirculation), "Perform the memory" or "Do not perform the memory" of the REC (recycle) switch ON (recirculation) condition can be selected.
- If "Perform the memory" was set, the REC (recycle) switch will be ON (recirculation) when turning the ignition switch to the ON position again.
- If "Do not perform the memory" was set, the air inlets will be controlled automatically when turning the ignition switch to the ON position again.
How to set
Using CONSULT-III, perform "REC MEMORY SET" in "WORK SUPPORT" of HVAC.
WORK SUPPORT ITEMS CHART
| Work support items | Display | Setting |
|---|---|---|
| REC MEMORY SET | WITHOUT | Perform the memory of manual REC |
| WITH (initial status) | Do not perform the memory of manual REC (auto control) |
NOTE:
When the battery cable is disconnected from the negative terminal or when the battery voltage becomes 10V or less, the setting of the REC switch memory function may be cancelled.