Diagnosis Procedure

1. CHECK RECLINING SWITCH SIGNAL
   1. Turn ignition switch OFF.
   2. Check voltage between driver seat control unit harness connector and ground.
   VOLTAGE REFERENCE CHART
   
   

   Driver seat control unit connector	Terminals		Condition		Voltage (V) (Approx.)
   	(+)	(-)
   B203	25	Ground	Reclining switch	Operate (forward)	0
   				Release	Battery voltage
   	9			Operate (backward)	0
   				Release	Battery voltage

   Is the inspection result normal? 

   YES: GO TO  5

   NO: GO TO 2

   Fig 1: Checking Voltage Between Driver Seat Control Unit Harness Connector And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.
2. CHECK RECLINING SWITCH CIRCUIT
   1. Turn ignition switch OFF.
   2. Disconnect driver seat control unit and power seat switch LH.
   3. Check continuity between driver seat control unit harness connector and power seat switch LH harness connector.
      CONTINUITY REFERENCE CHART
      
      

      Driver seat control unit connector	Terminal	Power seat switch LH connector	Terminal	Continuity
      B203 (A)	25	B213 (B)	5	Yes
      	9		10

   4. Check continuity between driver seat control unit harness connector and ground.
   Fig 2: Checking Continuity Between Driver Seat Control Unit Harness Connector And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.
   CONTINUITY REFERENCE CHART
   
   

   Driver seat control unit connector	Terminal	Ground	Continuity
   B203 (A)	25		No
   	9

   Is the inspection result normal? 

   YES: GO TO 3

   NO: Repair or replace harness.

3. CHECK DRIVER SEAT CONTROL UNIT OUTPUT
   1. Connect the driver seat control unit connector.
   2. Turn ignition switch ON.
   3. Check voltage between driver seat control unit harness connector and ground.
   VOLTAGE REFERENCE CHART
   
   

   Driver seat control unit connector	Terminals		Voltage (V) (Approx.)
   	(+)	(-)
   B203	9	Ground	Battery voltage
   	25

   Fig 3: Checking Voltage Between Driver Seat Control Unit Harness Connector And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

   Is the inspection result normal? 

   YES: GO TO 4

   NO: Replace driver seat control unit. Refer to "REMOVAL AND INSTALLATION ".

4. CHECK RECLINING SWITCH

   Refer to "COMPONENT INSPECTION ".

   Is the inspection result normal? 

   YES: GO TO 5

   NO: Replace power seat switch LH. Refer to "DRIVER SIDE: DISASSEMBLY AND ASSEMBLY ".

5. CHECK INTERMITTENT INCIDENT

Refer to "INTERMITTENT INCIDENT ".

Is the inspection result normal? 

YES: Replace driver seat control unit. Refer to "REMOVAL AND INSTALLATION ".

NO: Repair or replace the malfunctioning part.