LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 997 (Roof) >> With Single Panel Sunroof >> On-Vehicle Repair >> Sunroof Unit Assembly >> Removal and Installation >> Glass Lid Assembly

Glass Lid Assembly

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Removal 

  1. Open sunshade (1), then close glass lid assembly.

    <= Vehicle front

  2. Slide the side trim covers (2) RH/LH inward, then release them from the glass lid assembly inside edge and set aside.
  3. Remove the bolts (A) and glass lid assembly from sunroof unit assembly.
    Fig 1: Identifying Glass Lid Assembly Bolts
    G04888555Courtesy of NISSAN MOTOR CO., U.S.A.

Installation 

  1. Position glass lid assembly to sunroof unit assembly.
  2. Tighten glass lid assembly bolts to specification.
    NOTE: First tighten left front bolt, then right rear bolt on glass lid assembly to prevent uneven torque while tightening remaining bolts.
  3. Slide side trim covers onto inside edge of glass lid assembly.
  4. After installation, check sunroof operation and glass lid assembly alignment. Refer to "INSPECTION ".
scientia non olet · About LEMON Manuals