LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 996 (Power Window Control System) >> LH & RH Front Window Anti-Pinch >> On-Vehicle Repair >> Rear Power Window Switch >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery terminal.
  2. Using a suitable tool, remove the rear door arm rest finisher (1), then disconnect the harness connector. Refer to "EXPLODED VIEW ".
    CAUTION: Wrap a cloth around suitable tools to protect components from damage.
  3. Release the tabs on each side with suitable tool (A), then separate the rear power window switch (2) from the finisher (1) and remove.

    Pawl

    Fig 1: Disconnecting Harness Connector
    G05911141Courtesy of NISSAN MOTOR CO., U.S.A.


  1. Disconnect the negative battery terminal.
  2. Using a suitable tool, remove the rear door arm rest finisher (1), then disconnect the harness connector. Refer to "EXPLODED VIEW ".
    CAUTION: Wrap a cloth around suitable tools to protect components from damage.
  3. Release the tabs on each side with suitable tool (A), then separate the rear power window switch (2) from the finisher (1) and remove.

    Pawl

Fig 1: Disconnecting Harness Connector
G05911141Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals