LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 996 (Power Window Control System) >> LH & RH Front Window Anti-Pinch >> On-Vehicle Repair >> Front Power Window Switch >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery terminal.
  2. Using a suitable tool, remove the front door grip cover. Refer to "EXPLODED VIEW ".
    CAUTION: Do not fold the pawl of front power window switch finisher.
  3. Remove the front power window switch locking clip (A).
    Fig 1: Identifying Front Power Window Switch Locking Clip
    G05911139Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Release the metal clip, then lift the front power window switch and finisher as an assembly upward to remove it from the front door finisher.

    Metal clip

    Pawl

    CAUTION: Wrap a cloth around suitable tools to protect components from damage.
  5. Disconnect the harness connector.
  6. Release the tabs on each side, then separate the switch finisher (1) from the front power window switch (2) and remove.
Fig 2: Identifying Power Window Switch And Finisher
G05911140Courtesy of NISSAN MOTOR CO., U.S.A.


  1. Disconnect the negative battery terminal.
  2. Using a suitable tool, remove the front door grip cover. Refer to "EXPLODED VIEW ".
    CAUTION: Do not fold the pawl of front power window switch finisher.
  3. Remove the front power window switch locking clip (A).
    Fig 1: Identifying Front Power Window Switch Locking Clip
    G05911139Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Release the metal clip, then lift the front power window switch and finisher as an assembly upward to remove it from the front door finisher.

    Metal clip

    Pawl

    CAUTION: Wrap a cloth around suitable tools to protect components from damage.
  5. Disconnect the harness connector.
  6. Release the tabs on each side, then separate the switch finisher (1) from the front power window switch (2) and remove.
Fig 2: Identifying Power Window Switch And Finisher
G05911140Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals