REAR RH: Diagnosis Procedure

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK REAR POWER WINDOW MOTOR RH
Check rear power window motor RH. Refer to "REAR RH: COMPONENT INSPECTION ".

Is the inspection result normal?

YES: GO TO 2

NO: Replace rear power window motor RH. Refer to "REMOVAL AND INSTALLATION ".

CHECK REAR POWER WINDOW SWITCH RH OUTPUT SIGNAL

Disconnect rear power window motor RH connector.
Turn ignition switch ON.
Check voltage between rear power window motor RH connector D304 terminal 1, 3 and ground.

VOLTAGE SPECIFICATION

Terminal			Rear power window switch RH condition	Voltage (V) (Approx.)
(+)		(-)
Rear power window motor RH connector	Terminal	(-)
D304	3	Ground	UP	Battery voltage
	3		DOWN	0
	1		UP	0
	1		DOWN	Battery voltage

Fig 1: Checking Voltage Between Rear Power Window Motor LH Connector Terminals 1, 3 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

Is the inspection result normal?

YES: Refer to "INTERMITTENT INCIDENT ".

NO: GO TO 3

CHECK HARNESS CONTINUITY

Turn ignition switch OFF.
Disconnect rear power window switch RH connector.

Check continuity between rear power window switch RH connector D303 (A) terminals 4, 5 and rear power window motor RH connector D304 (B) terminals 1, 3.

CONTINUITY SPECIFICATION

Rear power window switch RH connector	Terminal	Rear power window motor RH connector	Terminal	Continuity
D303 (A)	5	D304 (B)	1	Yes
D303 (A)	4	D304 (B)	3	Yes

Fig 2: Checking Continuity Between Rear Power Window Switch LH Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

Check continuity between rear power window switch RH connector D303 (A) terminals 4, 5 and ground.

CONTINUITY SPECIFICATION

Rear power window switch RH connector	Terminal	Ground	Continuity
D303 (A)	5		No
	4

Is the inspection result normal?

YES: Check rear power window switch RH. Refer to "DIAGNOSIS PROCEDURE ".

NO: Repair or replace harness or connectors.