LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 996 (Power Window Control System) >> LH & RH Front Window Anti-Pinch >> Component Diagnosis >> Power Window Motor >> Passenger Side >> PASSENGER SIDE: Diagnosis Procedure

PASSENGER SIDE: Diagnosis Procedure

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FRONT POWER WINDOW MOTOR RH

    Check front power window motor RH. Refer to "PASSENGER SIDE: COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: GO TO 2

    NO: Replace front power window motor RH. Refer to "REMOVAL AND INSTALLATION ".

  2. CHECK FRONT POWER WINDOW SWITCH RH OUTPUT SIGNAL
    1. Disconnect front power window motor RH connector.
    2. Turn ignition switch ON.
    3. Check voltage between front power window motor RH connector D104 terminals 1, 2 and ground.
    VOLTAGE SPECIFICATION

    Terminal Front power window motor RH condition Voltage (V) (Approx.)
    (+) (-)
    Front power window motor RH connector Terminal
    D104 2 Ground UP Battery voltage
    DOWN 0
    1 UP 0
    DOWN Battery voltage
    Fig 1: Checking Voltage Between Front Power Window Motor LH Connector Terminals 1, 2 And Ground
    G05046749Courtesy of NISSAN MOTOR CO., U.S.A.

    Is the inspection result normal? 

    YES: Refer to "INTERMITTENT INCIDENT ".

    NO: GO TO 3

  3. CHECK HARNESS CONTINUITY
    1. Turn ignition switch OFF.
    2. Disconnect power window and door lock/unlock switch RH connector.
    3. Check continuity between power window and door lock/unlock switch RH connector D105 (A) terminals 8, 9 and front power window motor RH connector D104 (B) terminals 1, 2.
      CONTINUITY SPECIFICATION

      Power window and door lock/unlock switch RH connector Terminal Front power window motor RH connector Terminal Continuity
      D105 (A) 8 D104 (B) 2 Yes
      9 1
      Fig 2: Checking Continuity Between Power Window And Door Lock/Unlock Switch RH Connector And Front Power Window Motor RH Connector
      G05046805Courtesy of NISSAN MOTOR CO., U.S.A.
    4. Check continuity between power window and door lock/unlock switch RH connector D105 (A) terminals 8, 9 and ground.
    CONTINUITY SPECIFICATION

    Power window and door lock/unlock switch RH connector Terminal Ground Continuity
    D105 (A) 8 No
    9

    Is the inspection result normal? 

    YES: Replace power window and door lock/unlock switch RH. Refer to "REMOVAL AND INSTALLATION ".

    NO: Repair or replace harness or connectors.

scientia non olet · About LEMON Manuals