LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 995 (Brake Control System (VDC/TCS/Abs)) >> On-Vehicle Repair >> Abs Actuator And Electric Unit (Control Unit) >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative terminal.
  2. Drain the brake fluid. Refer to "DRAIN AND REFILL ".
    CAUTION: Do not reuse the brake fluid.
  3. Remove the front wiper arms. Refer to "FRONT WIPER ARMS: REMOVAL AND INSTALLATION ".
  4. Remove the cowl top and RH cowl top extension. Refer to "REMOVAL AND INSTALLATION ".
  5. Disconnect the wiper washer hose.
  6. Remove the tower bar. Refer to "EXPLODED VIEW ".
  7. Disconnect the ABS actuator and electric unit (control unit) connector.
  8. Loosen the brake tube flare nuts, then disconnect the brake tubes from the ABS actuator and electric unit (control unit).
  9. Remove the ABS actuator and electric unit (control unit) nuts.
  10. Remove the ABS actuator and electric unit (control unit).
  11. Remove the ABS actuator and electric unit (control unit) bracket as necessary.
scientia non olet · About LEMON Manuals