Diagnosis Procedure
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK CONNECTOR
- Turn ignition switch OFF.
- Disconnect ABS actuator and electric unit (control unit) connector.
- Check terminals for deformation, disconnection, looseness, and so on. If any malfunction is found, repair or replace terminals.
- Reconnect connector and perform self-diagnosis. Refer to "CONSULT-III FUNCTION (ABS) ".
SELF-DIAGNOSIS RESULTS
| Self-diagnosis results |
|---|
| CAN COMM CIRCUIT |
Is above displayed on the self-diagnosis display?
YES: Refer to "TROUBLE DIAGNOSIS FLOW CHART ".
NO: Inspection End.