Adjustment Of Steering Angle Sensor Neutral Position

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: To adjust neutral position of steering angle sensor, make sure to use CONSULT-III (Adjustment cannot be done without CONSULT-III)

ALIGN THE VEHICLE STATUS
Stop vehicle with front wheels in straight-ahead position.

: GO TO 2.
PERFORM THE NEUTRAL POSITION ADJUSTMENT FOR THE STEERING ANGLE SENSOR
1. On the CONSULT-III screen, touch "WORK SUPPORT", then "ST ANG SEN ADJUSTMENT".
2. Touch "START".
  CAUTION: Do not touch steering wheel while adjusting steering angle sensor.
3. After approximately 10 seconds, touch "END".
  NOTE: After approximately 60 seconds, the adjustment ends automatically.
4. Turn ignition switch OFF, then turn it ON again.
CAUTION: Be sure to perform above operation.

: GO TO 3.
CHECK DATA MONITOR
1. Run vehicle with front wheels in straight-ahead position, then stop.
2. Select "DATA MONITOR". Then make sure "STR ANGLE SIG" is within 0 ± 2.5°.
Is the steering angle within the specified range?

YES: GO TO 4.

NO: Perform the neutral position adjustment for the steering angle sensor again, GO TO 1.
ERASE THE SELF-DIAGNOSIS MEMORY
Erase the self-diagnosis memories of the ABS actuator and electric unit (control unit) and ECM.
- ABS actuator and electric unit (control unit): Refer to "CONSULT-III FUNCTION (ABS) ".
- ECM: Refer to "CONSULT-III FUNCTION ".

Are the memories erased?

YES: Inspection End

NO: Check the items indicated by the self-diagnosis.